Skip to content
LSLab

How Do Low-E and Multi-Pane Glass Reduce Heat Loss?

  • Intermediate
  • Article
  • Ages 16+
  • 2 min read
A window-glass unit stands on a wooden bench, viewed at an angle with parallel clear-glass edges and dark spacer bars.
Contents
Three upright panes stand parallel with two pale yellow gaps; a thick red arrow enters at left and a thin arrow leaves at right.
  • Three panes (three upright rectangles)
  • Two gas gaps between panes (pale yellow zones)
  • Heat going in (thick red arrow)
  • Heat that gets through (thin red arrow)

How do windows lose heat?

In a typical home, windows cover 10% of the surface area but can account for 30–40% of winter heat loss. Glass absorbs heat from sunlight and transfers it through the pane into the room.

What does low-e do?

A low-e coating blocks radiant energy while allowing visible light through.

Low-e products come in low, moderate and high solar-gain versions; low-gain products are designed for hot climates, while high-gain products are designed for cold climates.

What do extra panes and gas add?

High-performance windows use two or three insulated glass panes separated by insulating spacers and set in insulated frames. The spaces between panes can be filled with argon or krypton, which insulates better than air.

In thin-glass triple-pane designs, a third pane creates two gas spaces instead of one, and two low-e coatings reflect radiant heat.

For a new home, upgrading from double-pane to triple-pane windows can improve energy-efficiency performance by 40% or more. Window performance varies with climate, so that figure does not apply equally to every building.

A green stripe runs down the pane; the red line folds back to the left while the yellow line runs straight to the right.
  • Pane
  • Low-e coating (thin green stripe)
  • Radiant heat reflected (red line folding back)
  • Visible light passing through (yellow line)

What does the U-factor tell you?

The U-factor measures heat flow through glazing; the lower it is, the less heat passes through the window. Extra panes, low-e coatings and argon or krypton in the gaps can all lower the U-factor.

Window energy efficiency depends on the U-factor, solar heat gain coefficient (SHGC) and climate. In cold climates, a low U-factor reduces heat loss, while a high SHGC helps use the sun's heat. In warm climates, a low SHGC reduces unwanted solar heat gain.

Three red, yellow and green bars stand on one baseline, each shorter than the bar to its left.
  • Plain glass (tall red bar)
  • Partly improved glass (medium yellow bar)
  • Multi-pane glass with low-e and gas (short green bar)
  • Baseline

Terms in this article

English and Vietnamese terms, with the meanings used here. Hover, tap or Tab to a term with a dotted underline for an explanation as you read.

low-emissivity coatinglớp phủ low-e
A thin coating on glass that blocks radiant energy while letting visible light through.
panetấm kính
A single layer of glass in a window; a multi-pane window stacks several of them.
U-factorhệ số U
A measure of the rate at which heat passes through a window; the lower it is, the better the window holds heat.
radiant heatnhiệt bức xạ
Heat that travels as radiation, with no material needed in between.

This article is not marked as viewed

Spotted something wrong or unsafe?

Tell the administrator by email. The message already has the article title and address.

Report this article
See all articles of the topic

Sources

These sources are written for older readers. If they feel hard, read them with an adult.